Dual Platform Rubber Brake Pad Making Machine 1200 Ton Rubber Vulcanizing Press

1200 Ton Rubber Vulcanizing Press Rubber Brake Pad Making Machine Dual Platform

Operating Safety Specifications:

1. It is strictly prohibited to perform die closing action without mold or die thickness less than minimum mold thickness, otherwise it will cause serious equipment accident..
2. The floor and machine should be kept clean and avoid oil pollution to prevent slipping.
3. No tools, glue, etc on the working table of the machine.
4. When the machine is repaired or installed, any part of the body must enter the machine's range of action, the power must be cut off.
5. Clean the rubber at the high temperature of the machine, replace the mold or repair, must wear protective gloves.
6. If the product emits harmful gas, it is not allowed to operate the machine in confined spaces and ventilation equipment must be installed.

.

Mould Locking System:

It is mainly composed of mould locked cylinder, quick closing mould cylinder, top mould cylinder, template, hot plate and column. The center seat of the quick closing die cylinder drives up and down rapidly along the four columns, and the clamping force is up to 4000kN by the clamping cylinder when the die is in place. After opening the mold, the top mould cylinder will push out the product.

Machine Transportation:

• ​When lifting the crane, use a crane or hanger, and pay attention to whether the hoisting of the sling is sufficient. Before lifting, use soft objects to protect the machine so as to avoid scratches. The total weight of the machine is 28.5 tons
• During transportation, please pay attention to the necessary waterproof, moisture-proof and dustproof, while avoiding the sharp impact and collision. To ensure the performance and integrity of the machine.

Machine Main Applications:

It is used for other flat vulcanizing rubber molded products, such as: rubber / silicone products, seals, O-rings, oil seals, rubber shock pad, keyboard, medical rubber parts, electrical insulation parts and other kinds of rubber products and bakelite products , crafts and other models pressing. This equipment is mainly suitable for all kinds of automobile&motorcycle brake pads.

Machine Installations:

The machine should be placed on a solid foundation. Please put the rubber gasket on the machine when installing the machine, and place it in the air, dry and clean place. Machine installation is placed in a good and stable foundation to keep the machine from shaking, thus keeping the machine's accuracy, performance and service life in order to maintain the best operating efficiency and production capacity of the machine. The installation must be corrected, the base is flat on the lower heat plate, and the bearing capacity of the foundation is above 8t/m squared.

Machine Main Parameters:

Type: 6 Columns

Clamping Force: 1200 Tons

Oil Cylinder Mode: fast subsidiary cylinder

Plunger Diameter: Φ450 mm

Plunger Stroke: 350mm

Heating Plates Distance: 350-550mm

Plated Size: 1600x2200mm

Heating Mode: electric heating tube

Heating Power: 126KW(63KW x 2)

Mould Openning Mode: 2RT-UP/DWON

Main Cylinder Up Speed: Low Speed:1-6mm/s, High Speed: 60mm/s;

Main Cylinder Dwon Speed: Low Speed:1-6mm/s, High Speed: 80mm/s;

Max. Operating Pressure: 20MPa

Moto Power: 25HP(18.5KW x 2)

Max. Heating Temperature: 220℃

Gross weight: 28.5ton

Dimension: L2350*W5400*H2950 mm

STANDARD PARTS ALONG WITH MACHINE:

Reference Images: