Rubber injection machine is a common technology for producing rubber material molded products. Some people may not even remember its name because it is too long. The so-called rubber injection machine. It is mainly used for rubber gloves and electrical insulators. At the same time, it can also produce rubber injection molds for baking cakes. Rubber injection machines also play a very important role in the production of rubber products. It can be said that the emergence of this kind of equipment has once again promoted the development of the rubber industry, and has improved the production efficiency and product quality of all factories in the rubber industry. The rubber injection machine has also been maintained, but the strength may have some wear. After a period of friction. The model machine is prone to failure. If you want to reduce the number of malfunctioning rubber injection machines, get maintenance.
Several ways to maintain rubber injection machine:

1. The machine should be kept clean, and the wearing parts should be repaired or replaced in time.
2. Check whether the circulation of lubrication points and cooling water is normal during each shift.
3. Strict attention should be paid to avoid mixing water and impurities into the oil.
4. The fuel tank should have a certain amount of working oil to meet the maintenance requirements of the fuel injector. The oil level should be checked regularly. When the machine, clean the oil tank and oil filter. The working oil should be filtered and filled into the oil tank. After 3 months, it should be cleaned and replaced new engine oil. After this, the rubber injection machine should be cleaned and replaced every half an hour.
5. When the machine is trying to start, the oil pump should be started under no load and run for more than 5 minutes before running. If there are bubbles on the surface as a working fluid, check and tighten the oil inlet pipe of the oil pump in time to prevent ambient air from penetrating into the oil pump and damaging the oil pump.
6. Clean electrical contacts every month. If the contact point is hairy, it should be repaired or replaced according to the situation to ensure that the action is sensitive and the control box is kept dry and clean.
7. When the oil pump motor is working, no sundries can be placed between the moving template and the fixed template, so as to avoid damage to the machine and mold due to misoperation.
8. When preheating or not taking this injection technique for a long time, the rubber in the pre-plastic cylinder and injection cylinder should be cleaned up, and the injection seat should be restored to the stop working position.