Combined with the current development situation and market demand of the entire industry, the future demand for energy-saving rubber machinery is getting higher and higher. For example, in the vulcanizing machine type, plate type or jacket type circulating constant temperature heating technology and equipment can be widely developed, which can save energy even up to 50%. At the same time, intermittent rubber mixing equipment is developed in the direction of continuous rubber mixing equipment.
In this way, it will be able to improve the production efficiency of rubber machinery and equipment, while also reducing its energy consumption. The second is to move toward a single-operation equipment to mechanized, linkage, and automated combination equipment. Everyone should know that in today's society, mechanized, linked, and automated combination equipment can reduce the number of processes and unnecessary equipment, and at the same time it is easy to find a balance point of energy saving for the drive motor in the linkage.
That is to say, in the rubber machinery production process, through the improvement of its mechanical properties and automatic level, it will help overcome the defects of the traditional single operation equipment and greatly save energy. At the same time, the entire industry is still moving towards the adoption of efficient energy. Since the industrial revolution, steam heating has been applied to the heating of processing equipment in the industry. This heating method mainly uses the latent heat heating equipment of steam, and the heat energy of the wet heat part of the condensed water is not utilized, so the efficiency of steam heating is used. Very low.
Later, the use of electric energy significantly improved the heating efficiency, which greatly reduced the cost of using rubber machinery. Therefore, it is necessary and possible to use high-efficiency energy heating for rubber equipment. Moreover, the rubber equipment constant temperature control method is developed to adopt a closed cycle constant temperature control mode.
In general, in the rubber machinery production process, all the production links involving the heating part are often more suitable to use electric heating hot water circulation control technology and equipment, especially for energy saving, using electric heating and cold direct hot water. Circulating thermostatic control technology and devices are ideal, which not only saves energy but also saves a lot of cooling water.
Fax: 86-20-34812609