250 Ton Vacuum Compression Molding Machine / Silicone Cleaning Gloves Making Machine

Silicone Cleaning Gloves Molding Machine 250 Ton Vacuum Compression Molding Machine

 
Automatic Vacuum Compression Molding Machine Operation Principles:

1. The vulcanizer should use the handling equipment as much as possible when transporting. If it is transported by steel pipe, its diameter should not exceed 60mm. The machine should not be tilted excessively to prevent accidents and damage the parts and surface paint.
2. The vulcanizer should be placed on a stable surface and the horizontal and horizontal levels should be corrected with a level meter.
3. Add pure 68# anti-wear hydraulic oil to the fuel tank. The oil level should be above the top line of the oil level gauge. After the trial run, you need to make up.
4. Remove the sundries from the hot plate and adjust the red needle to the corresponding pressure according to the size of the mold. The maximum is not more than 20Mpa. The green needle is the automatic pressure, which is generally about 10% lower than the red needle. Fill the skateboard and roller with high temperature grease.
5. Turn on the three-phase four-wire power supply and rotate the “automatic” and “manual” to the automatic position. Press the "Reset" button, then press the "Stop" button to check that the end of the fully automatic vulcanizer motor shaft must be clockwise. The electric control box must be connected to the neutral line, and the main unit needs to be grounded with a 4 mm square wire.

Extend Lifespan of Vucuum Compression Molding Machine:
As a conveyor belt joint tool, the vulcanizer can extend the service life by focusing on daily maintenance.
Pay attention to the following issues when maintaining the vulcanizer:

1. The storage environment of the vulcanizer should be kept dry and well ventilated to avoid the wetness of the electrical circuit caused by moisture;
2. Do not use the vulcanizing machine outdoors on rainy days to prevent the electric control box and heating plate from entering the water;
3. If the working environment is damp and watery, when dismantling and handling the vulcanizing machine, the items on the ground should be raised, and the vulcanizer should not be in direct contact with water;
4. If the heating plate enters the water due to improper operation during the use, first contact the manufacturer for repair. If emergency repair is required, open the cover on the hot plate, pour the water out first, then set the electric control box to manual operation, warm to 100 ° C, keep the temperature for half an hour, dry the line, at The belt is glued in the manual state. At the same time, the manufacturer should be contacted in time to replace the entire line.
5. If the vulcanizer does not need to be used for a long time, the heating plate should be heated every half month (the temperature is set at 100 °C), and the temperature is maintained for about half an hour.
6. After each use, the water in the water pressure plate should be cleaned, especially in winter. If the water cannot be cleaned, the water pressure plate rubber will prematurely age and the service life of the water pressure plate will decrease.

The correct way to release water is to do so before the vulcanization is completed and the vulcanizer is not disassembled. If the water is released after the machine is disassembled, the water in the water pressure plate may not be completely discharged.
 
Main Parameters for Other Machines:

 
 
 

 
Finished Product: