200 Ton Automatic Alarm Function Rubber Injection Machine 3 RT Mold Openning

Dual Stages Feeding Lightning Arrester 500 Ton Injction Machine 3 RT Mold Openning

How the injection molding machine works:

The sequence of actions is carried out according to the steps of mode locking → shooting advancement → shot injection → product cooling → pressure holding → melting glue → shot back → mold → top output. Injection molding processing is to work in a cycle according to such a cycle.

Machine Maintenance Manual:

As a conveyor belt joint tool, the vulcanizing machine should be maintained and maintained in the same way as other tools during and after use to extend the service life. At present, the vulcanizing machine produced by Junan Machinery has a service life of 8 years as long as it is properly maintained.

The maintenance of the vulcanizer should be noted that the storage environment of the vulcanizer should be kept dry and well ventilated to avoid the wetness of the electrical circuit due to moisture; do not use the vulcanizer outdoors on rainy days to prevent the electric control box and the heating plate from entering the water; Wet, watery, when dismantling and handling the vulcanizing machine, the items should be raised on the ground, and the vulcanizer should not be in direct contact with water;

If the heating plate enters the water due to improper operation during use, first contact the manufacturer for repair. If emergency repair is required, open the cover on the hot plate, pour the water out first, then set the electric control box to manual operation, warm to 100 ° C, keep the temperature for half an hour, and dry the line. The belt is glued in the manual state. At the same time, the manufacturer should be contacted in time to make the overall replacement of the line.

When the vulcanizer does not need to be used for a long time, the heating plate should be heated every half month (temperature setting 100 ° C), and the temperature is maintained for about half an hour.

After each use, the water in the water pressure plate should be cleaned, especially in winter. If the water cannot be cleaned, the water pressure plate rubber will prematurely age and the service life of the water pressure plate will decrease.

The correct way to release water is after the vulcanization is completed and the vulcanizer is not removed before disassembly. If the water is released after the machine is disassembled, the water in the water pressure plate may not be completely discharged.

 
Machine Reference Images:

 
 
 
If you want machine video and see how our machine produce silicone rubber products ,
please send enquiry to us!