Fast Drop Rubber Press Machine For EPDM Material , 200 Ton Rubber Stopper Molding Vulcanizing Machine

rubber press machine for EPDM material, 200 ton rubber stopper molding vulcanizing machine
 

Machine characteristic:

1. The rapid rise of the template, slow lock, fast drop functions. Turning off the mold quickly and slowly and exhaust gas can be adjusted separately to improve production efficiency.

2. When the product is vulcanized, the oil pump motor stops working, and it has automatic pressure compensation function and oil pump stop delay. The oil route configuration is more reasonable and reliable.

3. deflation time, deflation times, heating temperature, curing time can be set, easy to operate.

4. Machine has automatic, semi-automatic two working modes. Set up the procedure for routine vulcanizing machine operation.

5. Use advanced technology hydraulic cylinder, reliable sealing, and long life.

6. The electrical system uses PC full computer control, full touch screen, control more convenient, accurate and reliable.

7. The hydraulic station adopts imported technology gear pump and medium-high pressure vane pump combination, hydraulic device, and proportional pressure flow compound valve control. Low noise and low energy consumption.

2RT Machine motion flow:

1. Setup the mold (initial status)
2. Supply the material and start the process(close the mold)
3. Load the mold
4. The main ram goes up to the predetermined position ready for entering a state of vacuum
5. Lower the vacuum mask. At the same time, suck out the air until a state of vacuum is reached.
6. The main ram goes up. Increase the pressure to expel bubbles out.
7. After the state of vacuum exist mo more, lift the vacuum hood and curing.
8. After curing, lower the main ram.
9. Unload the mold, open the mold.
10. Take out the final product and put new material in.