45KW 200 Ton Hydraulic Vacuum Compression Molding Machine With PLC System

200 Ton Hydraulic Pressing Machine Vacuum Pump Compression Machine with PLC System

Vacuum Compression Molding Machine General Information:

1. The vacuum vulcanizer should use the handling equipment as much as possible when transporting. If the diameter is not more than 60mm when transported with steel pipe, the machine should not be tilted excessively to prevent accidents from damaging the parts and surface paint.
2. The vacuum vulcanizer should be placed on a stable surface to correct the vertical and horizontal levels with a level meter.
3. Add pure 68# anti-wear hydraulic oil to the fuel tank. The height of the oil level should be up to the top of the oil level gauge.
4. Remove the sundries on the hot plate according to the size of the mold to adjust the red needle to the corresponding pressure, the maximum should not exceed 20Mpa. The green needle is generally about 10% lower than the red needle. Fill the skateboard and roller with high temperature grease.
5. Turn on the three-phase four-wire power supply and rotate the “automatic” and “manual” to the automatic position. Press the "Reset" button, then press the "Stop" button to check that the end of the fully automatic vulcanizer motor shaft must be clockwise. The electric control box must be connected to the neutral line, and the main unit needs to be grounded with a 4 mm square wire.

Brief Introduction to Vacuum Vulcanizing Machine:

Vacuum vulcanizing machine is suitable for producing all kinds of O-rings, rubber keyboards, medical rubber parts, automotive rubber parts and other miscellaneous rubber parts. It is economical, easy to operate, and has a fast forming speed. It can be used for three-layer mold release.

1. ★Structural characteristics:

The machine structure is subjected to computer pressure, strain analysis and long service life;
Special hot plate design, uniform temperature distribution, ensuring one-time molding quality;
The floating track mechanism ensures that the sliding plate does not rub against the hot plate;
High efficiency and fast vacuum system, the finished product is not short of material and contains no air bubbles.

2. ★Hydraulic system:

The hydraulic unit is integrated with the body, beautiful in design, no oil leakage, and can also be equipped with proportional pressure and flow system.

3. ★Electrical system:

PLC with touch screen control to improve product quality and stability.

Vacuum Compression Machine Parameters:

 
 
Machine Application Images: