Payment & Shipping Terms:
|Clamp Force:||200 Ton||Plate Size:||550x560mm|
|Total Capacity:||42kw||Gross Weight:||7.8 Ton|
|Machine Size:||L2930*W2350*H2230mm||Plunger Stroke:||250mm|
|Heater Capacity:||13.5kw *2||Tie Bar Distance:||650*320mm|
rubber vulcanizing equipment,
rubber vulcanization molding machine
200 Ton Hot Press Silicone Machine Plate Vulcanizing For Making Silicone Glove
1. before the experiment, check whether the required scale is reached in the fuel tank. Then check whether the components are working properly and whether the column is lubricated.
2. When the preheating is done, pay attention to the temperature of the hot plate. If it does not meet the requirements, it must be adjusted under the guidance of the engineer. It is strictly prohibited to tamper with it.
3. When placing the mold between the hot plates, it shall prevent burns or crush accidents. Do not place the mold when the hot plate rises.
4. In the middle of the tablet should be placed after the mold is loaded, people should stand in the center of the console. When the required pressure is reached after the mold is closed, the motor is turned off, and if it fails to meet the requirements, it must be adjusted by the engineer.
How to operate machine?
Initial state →Put the material into the mould, repos it the ejector cylinder →Load the mould →Close the mould quickly→ Clamp the mould slowly, increase pressure →Exhaust→ Vulcanization start →Vulcanization finish→ Open mould quickly→ Pushing out the mould →Ejector cylinder works, and separate mould and product→ Take out the product
200 Ton paremeter:
Machine main body item:
|1||solenoid valve||Taiwan Hytek|
|2||control system(PLC)||Japan Mitsubishi|
|3||solid state relay(SSR)||China Sonon|
|4||oil pump||Japan Yuken|
|5||human machine interface(HMI)||Taiwan Panelmaster|
|6||mold base casting||Ductile cast iron(QT500-07)|
|7||main cylinder||one piece cast molding, ductile cast iron(QT500-07)|
|8||main motor||Taiwan Tatung|
|9||with PLC contact protection device|
Contact Person: info