Payment & Shipping Terms:
|Clamp Force:||200 Ton||Plate Size:||550x560mm|
|Gross Weight:||7.8 Ton||Plunger Stroke:||250mm|
|Heater Capacity:||13.5kw *2||Tie Bar Distance:||650*320mm|
|Heating Plate Distance:||250-350mm||Motor Capacity:||7.5kw *2|
hydraulic vulcanizing machine,
rubber vulcanization molding machine
200 Ton Hydraulic Press Plate Vulcanizing Machine For Making Silicone Baby Spoon
1. before the experiment, check whether the required scale is reached in the fuel tank. Then check whether the components are working properly and whether the column is lubricated.
2. When the preheating is done, pay attention to the temperature of the hot plate. If it does not meet the requirements, it must be adjusted under the guidance of the engineer. It is strictly prohibited to tamper with it.
3. When placing the mold between the hot plates, it shall prevent burns or crush accidents. Do not place the mold when the hot plate rises.
4. In the middle of the tablet should be placed after the mold is loaded, people should stand in the center of the console. When the required pressure is reached after the mold is closed, the motor is turned off, and if it fails to meet the requirements, it must be adjusted by the engineer.
How to operate machine?
1. Checking state
2. feeding material into the mould,
3. Load the mould
4. Close the mould
5. Clamping the mould slowly, and pressure adding
6. Exhaust air
7. start Vulcanizing
8. finish Vulcanization
9. Open mould
10. Pushing out the mould
11. Separate the mould and product
12. Pick up finial product
Machine main body item:
|1||solenoid valve||Taiwan Hytek|
|2||control system(PLC)||Japan Mitsubishi|
|3||solid state relay(SSR)||China Sonon|
|4||oil pump||Japan Yuken|
|5||human machine interface(HMI)||Taiwan Panelmaster|
|6||mold base casting||Ductile cast iron(QT500-07)|
|7||main cylinder||one piece cast molding, ductile cast iron(QT500-07)|
|8||main motor||Taiwan Tatung|
|9||with PLC contact protection device|
Contact Person: info