Hot Sell Virus Prevention Mask Injection Machine

Hot Sell Virus Prevention Mask Injection Machine

Control System For Plate Vulcanizing Machine:

1. Compared with the automatic control of other industries, the control system of the flat vulcanizing unit is very different in many aspects. The most obvious one is that the latter basically belongs to the control of the process. Although there are many measurement and control parameters, each measurement and control parameter It may not need to be adjusted during the entire operation. The processed products belong to a single variety and large quantities. Various "industrial control configuration software" are developed for these systems.
2. The operation of the plate vulcanizing unit is exactly the opposite. Although each plate vulcanizing unit is formed into a set of control systems through the computer, the vulcanizing presses still maintain their own independence and there is no necessary connection between each other in work. Each vulcanizing press must implement temperature control according to the specific process curve of the tooling. The process of each flat vulcanizing unit is not fixed, and it needs to change with the workpiece and the processing process.
3. Therefore, it is required that the display, editing, and processing of the process curve must be intuitive and convenient. Check whether the water seepage part of the plate vulcanizer is the surface of the hydraulic plate or the contact ground between the surrounding rubber and the lower plate of the hydraulic plate. If there is water leakage in the surrounding gap, it should be Tighten the surrounding screws as a whole in order. If the leaking part is the rubber surface of the hydraulic pressure plate, and the leaking part is needle-shaped, in the case of emergency repair, 520 glue can be used to repair it, but the panel must be replaced after the repair is completed.
4. In order to ensure the stable and reliable operation of the system, our company provides system backup function. This computer system rescue software can fully realize the dynamic storage and recovery of computer system and CMOS data without occupying the practical space of the hard disk and without affecting the system performance. After the computer is installed with this function, you only need to press a button when it is infected with a virus, cannot access the Internet, crashed, damaged by hackers, and slower and slower. The computer will instantly return to normal. Vibration, impact and other combined forces during production and operation cause gaps in the parts and cause wear.
5. The traditional repair methods include surfacing welding, thermal spraying, electric brushing, etc., but several methods have certain drawbacks: surfacing welding will cause the surface of the part to reach a high temperature, causing deformation or cracking of the part, affecting the dimensional accuracy and normal use. In severe cases, it will also lead to fracture; although the brush crossing has no thermal influence, the thickness of the crossing layer should not be too thick, the pollution is serious, and the application is also greatly restricted.
6. At present, Western countries mostly apply polymer composite methods to address the above-mentioned problems. Among them, the most mature application of the 2500T large frame plate vulcanizing machine is the technology system of Mega Wah. Its comprehensive performance and the feature that it can be machined at any time can meet the requirements and accuracy of use after repair, and it can also reduce the impact and vibration of the equipment during operation and extend its service life.
7. Because the material is a "variable" relationship, when an external force impacts the material, the material will deform and absorb the external force, and expand and contract with the expansion and contraction of the bearing or other components, and always maintain a tight fit with the component to reduce the chance of wear. For the wear and tear of large-scale vulcanizers, "molds" or "matching parts" can also be used to repair damaged equipment on site, avoiding the overall disassembly of the equipment, ensuring the matching dimensions of parts to the greatest extent, and meeting the production and operation requirements of the equipment.

Main Parts Brand List: