High Efficiency Plate Vulcanizing Machine For Making Rubber Sponge

400 Ton Auto Parts Plate Vulcanizing Machine For Making Rubber Sponge

How to maintain machine?

1. The storage environment of the vulcanizer should be kept dry and well ventilated so as to avoid the humidity of the electrical circuit;

2. Do not use vulcanizing machines outdoors in rainy days to prevent water from entering the electric control box and heating plate;

3. if the working environment is humid, more water, when disassembling the handling vulcanizing machine, should be used in the ground to lift the goods, do not let the vulcanizer directly contact with water;

4. If in use, due to improper operation led to the heating plate water, should first contact the manufacturer for maintenance. If you need emergency repair, you can open the heating plate cover, first pour out the water, and then set the electric control box for manual operation, heated to 100 °C, maintain a constant temperature for half an hour, the line drying, in Belt glued in manual state. At the same time, the manufacturer should be promptly contacted for the complete replacement of the circuit.

5. If the vulcanizing machine does not need to be used for a long time, the heating plate should be heated every two weeks (the temperature is set at 100°C) and the temperature should be maintained for about half an hour.

Machine main body item brand name:

1. Solenoid valve: Taiwan Hytek
2. Control system(PLC): Japan Mitsubishi
3. Solid state relay(SSR):China Sonon
4. Oil pump:Japan Yuken
5. Human machine interface(HMI):Taiwan Panelmaster
6. Mold base casting:Ductile cast iron(QT500-07)
7. Main cylinder: one piece cast molding, ductile cast iron(QT500-07)
8. Main motor: Taiwan Tatung
9. With PLC contact protection device

Attention to Hydraulic system:

1. Hydraulic oil shall be 20 mechanical oil or 32. Hydraulic oil and oil must be filtered and then added.

2. Periodically release the oil, then use it for sedimentation and filtration, then clean the oil filter.

3. All parts of the machine should be kept clean, and the column shaft and guide frame should be constantly refueling to maintain good lubrication.

4. It is found that abnormal noise should be stopped immediately for inspection. After troubleshooting, it can continue to be used.

Technical parameter: