18 Cavities a Mold 400mm Plunger Stroke Car Brake Pads Making Hot Press Machine

18 Cavities a Mold 400mm Plunger Stroke Car Brake Pads Making Hot Press Machine

How to produce brake pads?

1. Mixing powder
2. put powder in to cool press machine
3. pick up formed mixture from cool press machine
4. Put formed mixture and steel back into hot press machine, then close the mold and waiting for curing
5. Put the pads into oven for baking
6. Put pads into Spray line for coating
7. put pads into the grinding machine and make it smooth
8. Put smooth pads into Slotted guide angle integrated machine
9. Spray coating for the steel back
10. Quality checking and packing

Machine spare part and brand :

Machine parameter:

18 cavities mold picture:

Machine Maintenance Manual:

1. Routine inspection and maintenance
2. Check the electric heating panel, check whether the heating plate is fixed and the wiring is short;
3. Check whether there is oil leakage or leakage in the motor oil pump, piping and valve;
4. Check the tank level；
5. Check the flow of cooling water;
6. Check the abnormal sound of motor oil pump, piping, valve, etc.；
7. The machine starts to run, and after a few hours, the oil temperature should be within the range of 35C ~ 50C；
8. Check whether system pressure is normal..
9. Weekly maintenance
10. whether the solenoid valve is super hot, check its vibration and wiring condition;
11. whether the fastening screws of the limit switch are loose;；
12. whether the pipe joints are loose or not;；
13. Whether the filter is blocked or not.