Product Details:
Payment & Shipping Terms:
|
Clamp Force: | 200 Ton | Plunger Stroke: | 250mm |
---|---|---|---|
Machine Size: | 2930*2350*2050mm | Plate Size: | 550*560mm |
Machine Type: | Vertical | Total Capacity: | 42kw |
Mold Open Way: | 2RT-3RT-4RT | Heating Way: | Electrical Heating |
High Light: | hydraulic vulcanizing machine,rubber vulcanization molding machine |
200~1000 Ton Electric Heating Plate Table Design Silicone Glove Molding Machine
machine details
1. Seamless steel pipe connection to ensure there is no oil spilling.
2. Quick die closing cylinder: good effect to machine capacity.
3. Special design for reinforcement, it has good bearing capacity.
4. Use solid state; it is very stable and durable when machine in moulding.
5. Double motor provide enough power to machine independently.
6. Strong electricity and weak electricity are separately, it can make sure machine has good stable performance.
Preparation before Operating vulcanizing machine
1. The hydraulic oil is checked before use. The height of the hydraulic oil is the height of the 2/3 in the lower frame. When the oil is insufficient, it should be added in time. It must be fine filtered before the injection of the oil is injected. Put pure 20# hydraulic oil into the injection hole of the lower seat. The height of the oil level is seen through the oil gauge bar, generally adding to the height of the 2/3 of the lower chassis.
2 Check the lubrication between the shaft and guide frame and fill it in time to maintain good lubrication.
3. The operation handle is connected to the power supply, the operation handle is moved to the vertical position, the return oil port is closed, the motor start button is pressed, the oil from the oil pump enters the oil cylinder, the driving plunger rises, when the hot plate is closed, the oil pump continues to supply oil, and the registration stop button is pressed when the oil pressure rises to the rated value (14.5MPa), so that the machine is in stop. When the machine is pressurized (i.e. timing vulcanization), when the curing time is reached, the handle is moved to make the plunger drop and open the mold.
200Ton machine specs:
Type: 4 Columns
Clamping Force: 200 Tons
Diameter of Cylinder: Φ350mm
Plunger Stroke: 250 mm
Open daylight: 250-350 mm
Heating Plate size: 550*560 mm
Distance of Tie bar: 650*320mm
Motor capacity: 7.5kw*2
Heater capacity: 13.5kw*2
Total capacity: 42kw
Gross weight: 7.8 ton
Dimension (L*W*H): 2930*2350*2050mm
Other specs:
|
Contact Person: info